Page 1 of 1
Pedestal Guard diameter
Posted: Mon Aug 30, 2010 9:13 am
by jtptdallas
Anybody know the pedestal guard diameter on the 2007 Catalina 350? It's either 1 1/4 " or 1 1/8" and I am ordering a snap on drink holder from Edson. Nobody seems to know, Catalina or Edson. My boats a 3 hour round trip so I was hoping not to run out and measure it, but someone at Marina can if no one out there knows!!
Thanks,
Jeff Thurston
Raise Me Up #417
Lake Texoma
Re: Pedestal Guard diameter
Posted: Mon Aug 30, 2010 10:00 am
by Richard Thabit
I have hull#111 and the diameter for my pedestal guard rails is 1 & 1/8 inch.
I purchased a drink holder from Snap It marine and it has been used for several years.
Check out "add on's" before you purchase.
Richard
Three Sheets
Re: Pedestal Guard diameter
Posted: Mon Aug 30, 2010 10:51 am
by jtptdallas
Richard (Three Sheets)
Thanks so much!! I think you just saved me 3 hours re pedestal guard!! JMT #417
Re: Pedestal Guard diameter
Posted: Mon Aug 30, 2010 10:54 am
by jtptdallas
Richard,
Do you know if your pedestal guard was 9 1/2 " or 12 1/2" diameter with the 1 1/8" tubing?
Jeff #417
Re: Pedestal Guard diameter
Posted: Mon Aug 30, 2010 11:03 am
by Richard Thabit
Sorry, I do not have that information. I bought it directly from Snap On several years ago and i do not recall them asking that dimension. I believe there is a photo of it mounted in the add on section of this website. You may be able to estimate from the photo.
Richard
Three Sheets